Display Ospf Vlink - 3Com S7906E Command Reference Manual

Field
Total Nets
Intra Area
Inter Area
ASE
NSSA

display ospf vlink

Syntax
display ospf [ process-id ] vlink
View
Any view
Default Level
1: Monitor level
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf vlink command to display OSPF virtual link information.
If no OSPF process is specified, the OSPF virtual link information of all OSPF processes is displayed.
Examples
# Display OSPF virtual link information.
<Sysname> display ospf vlink
OSPF Process 1 with Router ID 3.3.3.3
Virtual-link Neighbor-ID
Interface: 10.1.2.1 (Vlan-interface1)
Cost: 1562 State: P-2-P
Transit Area: 0.0.0.1
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Table 1-16 display ospf vlink command output description
Field
Virtual-link Neighbor-id
Neighbor-State
Interface
Cost
Total networks
Total intra-area routes
Total inter-area routes
Total ASE routes
Total NSSA routes
Virtual Links
-> 2.2.2.2, Neighbor-State: Full
Type: Virtual
ID of the neighbor connected to the router via the virtual link
Neighbor State: Down, Init, 2-Way, ExStart, Exchange, Loading, Full.
Local interface's IP address and name of the virtual link
Interface route cost
Description
Description
1-29