Authentication-Mode; Bandwidth-Reference (Ospf View) - 3Com S7906E Command Reference Manual

authentication-mode

Syntax
authentication-mode { simple | md5 }
undo authentication-mode
View
OSPF area view
Default Level
2: System level
Parameters
simple: Specifies the simple authentication mode.
md5: Specifies the MD5 ciphertext authentication mode.
Description
Use the authentication-mode command to specify an authentication mode for the OSPF area.
Use the undo authentication-mode command to remove the authentication mode.
By default, no authentication mode is configured for an OSPF area.
Routers that reside in the same area must have the same authentication mode: non-authentication,
simple, or MD5.
Related commands: ospf authentication-mode.
Examples
# Configure OSPF area 0 to use the MD5 ciphertext authentication mode.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 0
[Sysname-ospf-100-area-0.0.0.0] authentication-mode md5

bandwidth-reference (OSPF view)

Syntax
bandwidth-reference value
undo bandwidth-reference
View
OSPF view
Default Level
2: System level
Parameters
value: Bandwidth reference value for link cost calculation, in the range 1 to 2147483648 Mbps.
1-4