Pim Sm - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the pim require-genid command to enable rejection of hello messages without Generation_ID.
Use the undo pim require-genid command to restore the default configuration.
By default, hello messages without Generation_ID are accepted.
Examples
# Enable VLAN-interface 100 to reject hello messages without Generation_ID.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim require-genid

pim sm

Syntax
pim sm
undo pim sm
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the pim sm command to enable PIM-SM.
Use the undo pim sm command to disable PIM-SM.
By default, PIM-SM is disabled.
Note that this command can take effect only after IP multicast routing is enabled in the corresponding
instance.
Related commands: pim dm; multicast routing-table in the Multicast Routing and Forwarding
Commands in the IP Multicast Volume.
Examples
# Enable IP multicast routing, and enable PIM-SM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast routing-enable
1-40