Probe-Interval (Pim View) - 3Com S7906E Command Reference Manual

<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim trigged-hello-delay 3

probe-interval (PIM view)

Syntax
probe-interval interval
undo probe-interval
View
Public instance PIM view, VPN instance PIM view
Default Level
2: System level
Parameters
interval: Register probe time in seconds, with an effective range of 1 to 1799.
Description
Use the probe-interval command to configure the register probe time.
Use the undo probe-interval command to restore the system default.
By default, the register probe time is 5 seconds.
Related commands: register-suppression-timeout.
Examples
# Set the register probe time to 6 seconds in the public instance.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] probe-interval 6
register-policy (PIM view)
Syntax
register-policy acl-number
undo register-policy
View
Public instance PIM view, VPN instance PIM view
Default Level
2: System level
Parameters
acl-number: Advanced ACL number, in the range of 3000 to 3999. Only register messages that match
the permit statement of the ACL can be accepted by the RP.
1-44