3Com S7906E Command Reference Manual page 1282

Default Level
2: System level
Parameters
None
Description
Use the reflect between-clients command to enable route reflection between clients.
Use the undo reflect between-clients command to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a
route reflector are fully meshed, you need to disable route reflection between clients to reduce routing
costs.
Related commands: reflector cluster-id and peer reflect-client.
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] undo reflect between-clients
reflector cluster-id (MBGP family view)
Syntax
reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id
View
IPv4 MBGP address family view
Default Level
2: System level
Parameters
cluster-id: Cluster ID of the route reflector, in the range 1 to 4294967295.
ip-address: Cluster ID of the route reflector, in the format of an IP address.
Description
Use the reflector cluster-id command to configure the cluster ID of the route reflector.
Use the undo reflector cluster-id command to remove the configured cluster ID.
By default, each route reflector uses its router ID as the cluster ID.
A route is reflected by a route reflector from a client to another client. The router ID of the route reflector
is the ID of the cluster. You can configure multiple route reflectors to improve network stability. If a
1-46