Source-Lifetime (Ipv6 Pim View); Source-Policy (Ipv6 Pim View) - 3Com S7906E Command Reference Manual

Default Level
1: Monitor level
Parameters
interface-type interface-number: Specifies to reset the IPv6 PIM control message counter on a
particular interface. If no interface is specified, this command will clear the statistics information about
IPv6 PIM control messages on all interfaces.
Description
Use the reset pim ipv6 control-message counters command to reset IPv6 PIM control message
counters.
Examples
# Reset IPv6 PIM control message counters on all interfaces.
<Sysname> reset pim ipv6 control-message counters

source-lifetime (IPv6 PIM view)

Syntax
source-lifetime interval
undo source-lifetime
View
IPv6 PIM view
Default Level
2: System level
Parameters
interval: IPv6 multicast source lifetime in seconds, with an effective range of 1 to 65,535.
Description
Use the source-lifetime command to configure the IPv6 multicast source lifetime.
Use the undo source-lifetime command to restore the system default.
By default, the lifetime of an IPv6 multicast source is 210 seconds.
Examples
# Set the IPv6 multicast source lifetime to 200 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] source-lifetime 200

source-policy (IPv6 PIM view)

Syntax
source-policy acl6-number
1-42