Igmp-Snooping Last-Member-Query-Interval - 3Com S7906E Command Reference Manual

If configured in port group view, this feature takes effect only on those ports in this port group that
belong to the specified VLAN.
Examples
# Configure Ethernet 2/0/1 as a simulated member host in VLAN 2 for multicast source 1.1.1.1 and
multicast group 232.1.1.1.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] igmp-snooping host-join 232.1.1.1 source-ip 1.1.1.1 vlan 2

igmp-snooping last-member-query-interval

Syntax
igmp-snooping last-member-query-interval interval
undo igmp-snooping last-member-query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: Interval between IGMP last-member queries, in seconds. The effective range is 1 to 5.
Description
Use the igmp-snooping last-member-query-interval command to configure the interval between
IGMP last-member queries in the VLAN.
Use the undo igmp-snooping last-member-query-interval command to restore the default setting.
By default, the IGMP last-member query interval is 1 second.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: igmp-snooping enable, last-member-query-interval.
Examples
# Enable IGMP Snooping and set the interval between IGMP last-member queries to 3 seconds in
VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
1-15