Hello-Option Dr-Priority (Ipv6 Pim View) - 3Com S7906E Command Reference Manual

Parameters
acl6-number: Basic IPv6 ACL number, in the range of 2000 to 2999.
Description
Use the embedded-rp command to enable embedded RP.
Use the undo embedded-rp command to disable embedded RP or restore the system default.
By default, embedded RP is enabled for IPv6 multicast groups in the default embedded RP address
scopes.
The default embedded RP address scopes are FF7x::/12 and FFFx::/12. Here "x" refers to any legal
address scope. For details of the scope field, see Multicast Overview of the IP Multicast Volume.
Note that:
When you use the embedded-rp command without specifying acl6-number, the embedded RP
feature will be enabled for all the IPv6 multicast groups in the default embedded RP address
scopes; if you specify acl6-number, the embedded RP feature will be enabled for only those IPv6
multicast groups that are within the default embedded RP address scopes and pass the ACL
check.
When you use the undo embedded-rp command without specifying acl6-number, the embedded
RP feature will be disabled for all the IPv6 multicast groups; if you specify acl6-number, this
command will restore the system default.
Examples
# Enable embedded RP for only those IPv6 multicast groups in the address scope
FF7E:140:20::101/64.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff7e:140:20::101 64
[Sysname-acl6-basic-2000] quit
[Sysname] pim ipv6
[Sysname-pim6] embedded-rp 2000

hello-option dr-priority (IPv6 PIM view)

Syntax
hello-option dr-priority priority
undo hello-option dr-priority
View
IPv6 PIM view
1-22