Max-Response-Time (Mld-Snooping View) - 3Com S7906E Command Reference Manual

undo last-listener-query-interval
View
MLD-Snooping view
Default Level
2: System level
Parameters
interval: MLD last listener query interval in units of seconds, namely the length of time the device waits
between sending MLD multicast-address-specific queries. The effective range is 1 to 5.
Description
Use the last-listener-query-interval command to configure the MLD last listener query interval
globally.
Use the undo last-listener-query-interval command to restore the system default.
By default, the MLD last listener query interval is 1 second.
This command works only on MLD Snooping–enabled VLANs, but not on VLANs with MLD enabled on
their VLAN interfaces.
Related commands: mld-snooping last-listener-query-interval.
Examples
# Set the MLD last listener query interval to 3 seconds globally.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] last-listener-query-interval 3

max-response-time (MLD-Snooping view)

Syntax
max-response-time interval
undo max-response-time
View
MLD-Snooping view
Default Level
2: System level
Parameters
interval: Maximum response time for MLD general queries, in units of seconds. The effective range is 1
to 25.
Description
Use the max-response-time command to configure the maximum response time for MLD general
queries globally.
1-7