Display Multicast Rpf-Info - 3Com S7906E Command Reference Manual

RPF Neighbor
Matched routing protocol
Route-policy
Preference
Order

display multicast rpf-info

Syntax
display multicast [ all-instance | vpn-instance vpn-instance-name ] rpf-info source-address
[ group-address ]
View
Any view
Default Level
1: Monitor level
Parameters
all-instance: Specifies all instances.
vpn-instance vpn-instance-name: Specifies a VPN instance. A VPN instance name is a case sensitive
string of up to 31 characters and must not contain any space..
source-address: Multicast source address.
group-address: Multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
Description
Use the display multicast rpf-info command to view the RPF information of a multicast source.
Note that if neither all-instance nor vpn-instance is specified, this command displays the information
on the public instance.
Related commands: display multicast routing-table, display multicast forwarding-table.
Examples
# View all the RPF information of multicast source 192.168.1.55 in the public network.
<Sysname> display multicast rpf-info 192.168.1.55
RPF information about source 192.168.1.55:
VPN instance: public net
RPF interface: Vlan-interface1, RPF neighbor: 10.1.1.1
Referenced route/mask: 192.168.1.0/24
Referenced route type: igp
Field
1-8
Description
IP address of the RPF neighbor through which
the multicast source is reachable
If a protocol is configured, the multicast source
address of the route should be the destination
address of an entry in unicast routing table.
Routing policy. The multicast source address of
the route should match the routing policy.
Route preference
Sequence number of the route