Display Ipv6 Neighbors Count - 3Com S7906E Command Reference Manual

Field
State
T
Age

display ipv6 neighbors count

Syntax
display ipv6 neighbors { { all | dynamic | static } [ slot slot-number ] | interface interface-type
interface-number | vlan vlan-id } count
View
Any view
Default Level
1: Monitor level
Parameters
all: Displays the total number of all neighbor entries, including neighbor entries acquired dynamically
and configured statically.
dynamic: Displays the total number of all neighbor entries acquired dynamically.
static: Displays the total number of neighbor entries configured statically.
slot slot-number: Displays the total number of neighbor entries of a specified slot.
interface interface-type interface-number: Displays the total number of neighbor entries of a specified
interface.
vlan vlan-id: Displays the total number of neighbor entries of a specified VLAN whose ID ranges from 1
to 4094.
Description
Use the display ipv6 neighbors count command to display the total number of neighbor entries
satisfying the specified condition.
Examples
# Display the total number of neighbor entries acquired dynamically.
State of a neighbor, including:
INCMP: The address is being resolved. The link layer address of the
neighbor is unknown.
REACH: The neighbor is reachable.
STALE: The reachability of the neighbor is unknown. The device will
not verify the reachability any longer unless data is sent to the
neighbor.
DELAY: The reachability of the neighbor is unknown. The device
sends an NS message after a delay.
PROBE: The reachability of the neighbor is unknown. The device
sends an NS message to verify the reachability of the neighbor.
Type of neighbor information, including static configuration and dynamic
acquisition.
For a static entry, a hyphen "-" is displayed. For a dynamic entry, the
reachable time (in seconds) elapsed is displayed, and if it is never
reachable, "#" is displayed (for a neighbor acquired dynamically).
1-10
Description