Table 1-1 display pim ipv6 bsr-info command output description
Elected BSR Address
Candidate BSR Address
Priority
Hash mask length
State
Uptime
Next BSR message scheduled at
Candidate RP
Priority
HoldTime
Advertisement Interval
Next BSR message scheduled at
display pim ipv6 claimed-route
Syntax
display pim ipv6 claimed-route [ ipv6-source-address ]
View
Any view
Default Level
1: Monitor level
Parameters
ipv6-source-address: Displays the information of the IPv6 unicast route to a particular IPv6 multicast
source. If you do not provide this argument, this command will display the information about all IPv6
unicast routes used by IPv6 PIM.
Description
Use the display pim ipv6 claimed-route command to view the information of IPv6 unicast routes used
by IPv6 PIM.
If an (S, G) is marked SPT, this (S, G) entry uses an IPv6 unicast route.
Examples
# View the information of all IPv6 unicast routes used by IPv6 PIM.
<Sysname> display pim ipv6 claimed-route
RPF information about: 2001::2
RPF interface: Vlan-interface1, RPF neighbor: FE80::A01:100:1
Field
1-10
Description
IPv6 address of the elected BSR
Address of the candidate BSR
BSR priority
Hash mask length
BSR state
Length of time since this BSR was elected
Remaining time of this BSR
Address of the C-RP
Priority of the C-RP
Timeout time of the C-RP
Interval between C-RP-Adv messages
Remaining time before the C-RP will send the
next C-RP-Adv message
Need help?
Do you have a question about the S7906E and is the answer not in the manual?