Display Multicast Routing-Table Static - 3Com S7906E Command Reference Manual

If neither all-instance nor vpn-instance is specified, this command displays the information on the
public instance.
Multicast routing tables are the basis of multicast forwarding. You can view the establishment state
of an (S, G) entry by checking the multicast routing table.
Related commands: display multicast forwarding-table.
Examples
# View the routing information in the multicast routing table of the public instance.
<Sysname> display multicast routing-table
Multicast routing table of VPN-Instance: public net
Total 1 entry
00001. (172.168.0.2, 227.0.0.1)
Uptime: 00:00:28
Upstream Interface: Vlan-interface1
List of 2 downstream interfaces
1:
2:
Table 1-4 display multicast routing-table command output description
Multicast routing table of VPN-Instance: public
net
Total 1 entry
00001
(172.168.0.2, 227.0.0.1)
Uptime
Upstream interface
List of 2 downstream interfaces

display multicast routing-table static

Syntax
display multicast routing-table [ all-instance | vpn-instance vpn-instance-name ] static [ config ]
[ source-address { mask-length | mask } ]
View
Any view
Default Level
1: Monitor level
Vlan-interface2
Vlan-interface3
Field
Multicast routing table for the public network
Total number of (S, G) entries in the multicast
routing table
Sequence number of the (S, G) entry
An (S, G) entry of the multicast forwarding table
Length of time for which the (S, G) entry has
been up, in hours:minutes:seconds
Upstream interface the (S, G) entry: multicast
packets should arrive at this interface
Downstream interface list: these interfaces need
to forward multicast packets
1-6
Description