Register-Whole-Checksum (Ipv6 Pim View); Reset Pim Ipv6 Control-Message Counters - 3Com S7906E Command Reference Manual

By default, the register suppression time is 60 seconds.
Related commands: probe-interval, register-policy.
Examples
# Set the register suppression time to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-suppression-timeout 70

register-whole-checksum (IPv6 PIM view)

Syntax
register-whole-checksum
undo register-whole-checksum
View
IPv6 PIM view
Default Level
2: System level
Parameters
None
Description
Use the register-whole-checksum command to configure the router to calculate the checksum based
on the entire register message.
Use the undo register-whole-checksum command to restore the default configuration.
By default, the checksum is calculated based only on the header in the register message.
Related commands: register-policy, register-suppression-timeout.
Examples
# Configure the router to calculate the checksum based on the entire register message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-whole-checksum

reset pim ipv6 control-message counters

Syntax
reset pim ipv6 control-message counters [ interface interface-type interface-number ]
View
User view
1-41