Ripng Default-Route - 3Com S7906E Command Reference Manual

View
System view
Default Level
2: System level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535. The default value is 1.
Description
Use the ripng command to create a RIPng process and enter RIPng view.
Use the undo ripng command to disable a RIPng process.
By default, no RIPng process is enabled.
Examples
# Create RIPng process 100 and enter its view.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100]
# Disable RIPng process 100.
[Sysname] undo ripng 100

ripng default-route

Syntax
ripng default-route { only | originate } [ cost cost ]
undo ripng default-route
View
Interface view
Default Level
2: System level
Parameters
only: Indicates that only the IPv6 default route (::/0) is advertised through the interface.
originate: Indicates that the IPv6 default route (::/0) is advertised without suppressing other routes.
cost: Metric of the advertised default route, in the range of 1 to 15, with a default value of 1.
Description
Use the ripng default-route command to advertise a default route with the specified routing metric to a
RIPng neighbor.
Use the undo ripng default-route command to stop advertising or forwarding the default route.
By default, a RIP process does not advertise any default route.
1-11