Peer Route-Policy (Ipv6 Address Family View) - 3Com S7906E Command Reference Manual

Parameters
group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
prefix number: Specifies the upper limit of prefixes that can be received from the peer or peer group.
The limit varies with devices.. When the received prefixes from the peer/peer group reach the specified
upper limit, the router will disconnect from the peer/peer group.
alert-only: When the received prefixes from the peer/peer group reach the specified upper limit, the
router will display alarm messages rather than disconnect from the peer/peer group.
reconnect-time: Interval for the router to reconnect to the peer/peer group. The argument has no default.
It ranges from 1 to 65535 seconds.
percentage: Specifies a percentage value. If the percentage of received routes to the upper limit
reaches the value, the router will generate alarm messages. The default is 75. The value is in the range
1 to 100.
Description
Use the peer route-limit command to set the maximum number of prefixes that can be received from a
peer/peer group.
Use the undo peer route-limit command to restore the default.
By default, the router has no limit on prefixes from a peer/peer group.
The router will end the peer relation when the number of address prefixes received for the peer exceeds
the limit.
Examples
# Set the number of prefixes allowed to receive from the peer 1:2::3:4 to 100.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 route-limit 100

peer route-policy (IPv6 address family view)

Syntax
peer { group-name | ipv4-address | ipv6-address } route-policy route-policy-name { import | export }
undo peer { group-name | ipv4-address | ipv6-address } route-policy route-policy-name { import |
export }
View
IPv6 address family view
Default Level
2: System level
1-42