3Com S7906E Command Reference Manual page 794

View
OSPF area view
Default Level
2: System level
Parameters
no-summary: Usable only on a stub ABR. With it configured, the ABR advertises only a default route in
a Summary LSA into the stub area (such a stub area is known as a totally stub area).
Description
Use the stub command to configure an area as a stub area.
Use the undo stub command to remove the configuration.
No area is stub area by default.
Note that, to concel the no-summary configuration on the ABR, simply execute the stub command
again to overwrite it.
To configure an area as a stub area, all routers attached to it must be configured with this command.
Related commands: default-cost.
Examples
# Configure Area1 as a stub area.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] stub
stub-router
Syntax
stub-router
undo stub-router
View
OSPF view
Default Level
2: System level
Parameters
None
Description
Use the stub-router command to configure the router as a stub router.
Use the undo stub-router command to restore the default.
By default, no router is configured as a stub router.
1-62