Display Ripng Route - 3Com S7906E Command Reference Manual

display ripng route

Syntax
display ripng process-id route
View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
Description
Use the display ripng route command to display all RIPng routes and timers associated with each
route of a RIPng process.
Examples
# Display the routing information of RIPng process 100.
<Sysname> display ripng 100 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::200:5EFF:FE04:B602
Dest 3FFE:C00:C18:1::/64,
via FE80::200:5EFF:FE04:B602, cost
Dest 3FFE:C00:C18:2::/64,
via FE80::200:5EFF:FE04:B602, cost
Table 1-4 display ripng route command output description
Field
Peer
Dest
via
cost
tag
Sec
"A"
"S"
"G"
on Vlan-interface100
2, tag 0, A, 34 Sec
2, tag 0, A, 34 Sec
Description
Neighbor connected to the interface
IPv6 destination address
Next hop IPv6 address
Routing metric value
Route tag
Time that a route entry stays in a particular state
The route is in the aging state.
The route is in the suppressed state.
The route is in the Garbage-collect state.
1-6