Dhcp Select Server Global-Pool - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the dhcp enable command to enable DHCP.
Use the undo dhcp enable command to disable DHCP.
By default, DHCP is disabled.
You need to enable DHCP before performing DHCP server and relay agent configurations.
Examples
# Enable DHCP.
<Sysname> system-view
[Sysname] dhcp enable

dhcp select server global-pool

Syntax
dhcp select server global-pool [ subaddress ]
undo dhcp select server global-pool subaddress
View
Interface view
Default Level
2: System level
Parameters
subaddress: Supports subaddress allocation. That is, the DHCP server and clients are on the same
network segment, and the server allocates IP addresses from the address pool containing the network
segment of the first subaddress if several subaddresses exist.
Description
Use the dhcp select server global-pool command to enable the DHCP server on specified
interface(s). After the interface receives a DHCP request, the DHCP server will allocate an IP address
from the address pool.
Use the undo dhcp select server global-pool subaddress command to cancel the support for
subaddress allocation.
1-3