Peer Advertise-Community (Ipv6 Mbgp Address Family View) - 3Com S7906E Command Reference Manual

Note the following:
The network to be injected must exist in the local IPv6 routing table. You can use a route policy to
control the advertisement of the route with more flexibility.
The route injected with the network command has the IGP origin attribute.
Examples
# inject the network 2002::/16.
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp]ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] network 2002:: 16

peer advertise-community (IPv6 MBGP address family view)

Syntax
peer { ipv6-group-name | ipv6-address } advertise-community
undo peer { ipv6-group-name | ipv6-address } advertise-community
View
IPv6 MBGP address family view
Default Level
2: System level
Parameters
group-name: Name of an IPv6 MBGP peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of an IPv6 MBGP peer.
Description
Use the peer advertise-community command to advertise the community attribute to an IPv6 MBGP
peer/peer group.
Use the undo peer advertise-community command to remove the configuration.
By default, no community attribute is advertised to any IPv6 MBGP peer group/peer.
Examples
# Advertise the community attribute to the IPv6 MBGP peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 as-number 100
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 enable
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 advertise-community
1-29