Ospf Timer Dead; Ospf Packet-Process Prioritized-Treatment - 3Com S7906E Command Reference Manual

When the network type of an interface is NBMA, you need to use the peer command to specify a
neighbor.
If only two routers run OSPF on a network segment, you can configure associated interfaces'
network type as P2P.
Related commands: ospf dr-priority.
This command is not supported on the null or loopback interfaces.
Examples
# Configure the interface's network type as NBMA.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf network-type nbma

ospf packet-process prioritized-treatment

Syntax
ospf packet-process prioritized-treatment
undo ospf packet-process prioritized-treatment
View
System view
Parameters
None
Description
Use the ospf packet-process prioritized-treatment command to enable OSPF to give priority to
receiving and processing Hello packets.
Use the undo ospf packet-process prioritized-treatment command to restore the default.
By default, this function is not enabled.
Examples
# Enable OSPF to give priority to receiving and processing Hello packets.
<Sysname> system-view
[Sysname] ospf packet-process prioritized-treatment

ospf timer dead

Syntax
ospf timer dead seconds
1-51