Interface Tunnel - 3Com S7906E Command Reference Manual

Table 1-3 display ipv6 interface tunnel command output description
Field
*down
(s)
Interface
Physical
Protocol
IPv6 Address

interface tunnel

Syntax
interface tunnel number
undo interface tunnel number
View
System view
Default Level
2: System level
Parameters
number: Tunnel interface number. The tunnel interface number is in the A/B/C format, where A, B, and
C represent the slot number of a card, the slot number of a sub-card, and the tunnel interface number,
respectively. The value ranges of A and B vary with devices, and that of C is from 0 to 1023.
Description
Use the interface tunnel command to create a tunnel interface and enter tunnel interface view.
Use the undo interface tunnel command to remove the specified tunnel interface.
By default, there is no tunnel interface on the device.
Executing the interface tunnel command enters interface view of a specified tunnel. If no tunnel
interface is created, executing this command first creates a tunnel and then enters the tunnel
interface view.
A tunnel interface number has only local significance, and therefore, the same interface number or
different interface numbers can be set at both ends of a tunnel.
Related commands: display interface tunnel, source, destination, tunnel-protocol.
Examples
# Create the interface tunnel 2/0/3.
<Sysname> system-view
The tunnel interface is in administrative down state, meaning the
interface is shut down using the shutdown command.
Spoofing feature of the tunnel interface. That is, although the link-layer
protocol state of the interface is up, no such link exists, or the link is not
a permanent one and can only be established as needed.
Name of the tunnel interface
Physical state of the tunnel interface
Link-layer protocol state of the tunnel interface
IPv6 address of the tunnel interface. Only the first configured IPv6
address is displayed
1-7
Description