Display Arp Detection - 3Com S7906E Command Reference Manual

Parameters
disable: Disables ARP packet rate limit.
pps: ARP packet rate in pps, in the range 50 to 500.
drop: Discards the exceeded packets.
Description
Use the arp rate-limit command to configure or disable ARP packet rate limit. If a rate is specified,
exceeded packets are discarded.
Use the undo arp rate-limit command to restore the default.
By default, ARP packet rate limit is enabled, and the ARP packet rate is 100 pps.
Examples
# Specify the ARP packet rate on GigabitEthernet 2/0/1 as 30 pps, and exceeded packets are
discarded.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] arp rate-limit rate 30 drop

display arp detection

Syntax
display arp detection
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display arp detection command to display the VLAN(s) enabled with ARP detection.
Related commands: arp detection enable.
Examples
# Display the VLANs enabled with ARP detection.
<Sysname> display arp detection
ARP detection is enabled in the following VLANs:
1, 2, 4-5
3-6