Dhcp Client Configuration Commands; Display Dhcp Client - 3Com S7906E Command Reference Manual

3

DHCP Client Configuration Commands

The DHCP client configuration is supported only on VLAN interfaces.
When multiple VLAN interfaces having the same MAC address use DHCP for IP address
acquisition via a relay agent, the DHCP server cannot be the Windows 2000 Server or Windows
2003 Server.
You are not recommended to enable both the DHCP client and the DHCP snooping on the same
switch. Otherwise, DHCP snooping entries may fail to be generated, or the DHCP client may fail to
obtain an IP address.
You cannot configure an interface of an aggregation group as a DHCP client.
DHCP Client Configuration Commands

display dhcp client

Syntax
display dhcp client [ verbose ] [ interface interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
verbose: Specifies verbose DHCP client information to be displayed.
interface interface-type interface-number: Specifies an interface of which to display DHCP client
information.
Description
Use the display dhcp client command to display DHCP client information. If no interface
interface-type interface-number is specified, DHCP client information of all interfaces will be displayed.
Examples
# Display DHCP client information of all interfaces.
<Sysname> display dhcp client
Vlan-interface1 DHCP client information:
3-1