Table of Contents
Advertisement
Configuring WPA2
181
Changing the TKIP
To change the TKIP countermeasures timer, see "Changing the TKIP
Countermeasures
Countermeasures Timer Value" on page 181. The procedure is the same
Timer Value
for WPA and RSN.
Enabling PSK
To enable PSK authentication, see "Enabling PSK Authentication" on
Authentication
page 181. The procedure is the same for WPA and RSN.
Displaying RSN
To display the RSN settings in a service profile, use the following
Settings
command:
display service-profile {name | ?}
The RSN settings appear at the bottom of the output.
RSN-related fields appear in the display service-profile output only
when RSN is enabled.
Assigning the Service
After you configure RSN settings in a service profile, you can map the
Profile to Radios and
service profile to a radio profile, assign the radio profile to radios, and
Enabling the Radios
enable the radios to activate the settings.
To map a service profile to a radio profile, use the following command:
set radio-profile name service-profile name
To assign a radio profile to radios and enable the radios, use the
following command:
set ap port-list radio {1 | 2} radio-profile name
mode {enable | disable}
To map service profile rsn to radio profile bldg2, type the following
command:
WX1200# set radio-profile blgd2 service-profile rsn
success: change accepted.
Advertisement
Table of Contents
