Ospf Timer Hello - 3Com S7906E Command Reference Manual

undo ospf timer dead
View
Interface view
Default Level
2: System level
Parameters
seconds: Dead interval in seconds, in the range 1 to 2147483647.
Description
Use the ospf timer dead command to set the dead interval.
Use the undo ospf timer dead command to restore the default.
The dead interval defaults to 40s for Broadcast, P2P interfaces and defaults to 120s for P2MP and
NBMA interfaces.
If an interface receives no hello packet from the neighbor within the dead interval, the interface
considers the neighbor down. The dead interval on an interface is at least four times the hello interval.
Any two routers attached to the same segment must have the same dead interval.
This configuration is not supported on the null interface.
Related commands: ospf timer hello.
Examples
# Configure the dead interval on the current interface as 60 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf timer dead 60

ospf timer hello

Syntax
ospf timer hello seconds
undo ospf timer hello
View
Interface view
Default Level
2: System level
Parameters
seconds: Hello interval in seconds, in the range 1 to 65535.
Description
Use the ospf timer hello command to set the hello interval on an interface.
Use the undo ospf timer hello command to restore the default hello interval on an interface.
1-52