Mld-Snooping Fast-Leave - 3Com S7906E Command Reference Manual

Examples
# Enable MLD Snooping in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable

mld-snooping fast-leave

Syntax
mld-snooping fast-leave [ vlan vlan-list ]
undo mld-snooping fast-leave [ vlan vlan-list ]
View
Ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
Description
Use the mld-snooping fast-leave command to enable fast leave processing on the current port or
group of ports.
Use the undo mld-snooping fast-leave command to disable fast leave processing on the current port
or group of ports.
By default, fast leave processing is disabled.
Note that:
This command works on both MLD Snooping–enabled VLANs and VLANs with MLD enabled on
their VLAN interfaces.
If you do not specify any VLAN when using this command in Ethernet interface view or Layer 2
aggregate interface view, the command will take effect for all VLANs the interface belongs to; if you
specify a VLAN or multiple VLANs, the command will take effect only if the interface belongs to the
specified VLAN(s).
If you do not specify any VLAN when using this command in port group view, the command will
take effect on all the ports in this group; if you specify a VLAN or multiple VLANs, the command will
take effect only on those ports in this group that belong to the specified VLAN(s).
Related commands: fast-leave.
1-10