Peer Route-Limit (Ipv6 Mbgp Address Family View) - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
ipv6-group-name: Name of an IPv6 MBGP peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of an IPv6 MBGP peer.
Description
Use the peer reflect-client command to configure the router as a route reflector and specify an IPv6
MBGP peer/peer group as its client.
Use the undo peer reflect-client command to remove the configuration.
By default, neither route reflector nor client is configured.
Related commands: reflect between-clients, reflector cluster-id.
Examples
# Configure the local device as a route reflector and specify the peer group test as a client.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test internal
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer test enable
[Sysname-bgp-af-ipv6-mul] peer test reflect-client

peer route-limit (IPv6 MBGP address family view)

Syntax
peer { ipv6-group-name | ipv6-address } route-limit limit [ percentage ]
undo peer { ipv6-group-name | ipv6-address } route-limit
View
IPv6 MBGP address family view
Default Level
2: System level
Parameters
ipv6-group-name: Name of an IPv6 MBGP peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of an IPv6 MBGP peer.
limit: Specifies the upper limit of IPv6 address prefixes that can be received from the peer or peer group,
in the range 1 to 6144.
percentage: If the number of received routes divided by the upper limit reaches the specified
percentage, the system will generate alarm information. The percentage is in the range 1 to 100. The
default is 75.
1-40