If-Match Ipv6 - 3Com S7906E Command Reference Manual

Field
ge
Le

if-match ipv6

Syntax
if-match ipv6 { address | next-hop | route-source } { acl acl6-number | prefix-list ipv6-prefix-name }
undo if-match ipv6 { address | next-hop | route-source } [ acl | prefix-list ]
View
Route policy view
Default Level
2: System level
Parameters
address: Matches the destination address of IPv6 routing information.
next-hop: Matches the next hop of IPv6 routing information.
route-source: Matches the source address of IPv6 routing information.
acl acl6-number: Specifies the number of an IPv6 ACL for filtering, in the range 2000 to 3999 for
address, and 2000 to 2999 for next-hop and route-source.
prefix-list ipv6-prefix-name: Specifies the name of a IPv6 prefix list for filtering, a string of 1 to 19
characters.
Description
Use the if-match ipv6 command to configure a destination, next hop or source address based match
criterion for IPv6 routes.
Use the undo if-match ipv6 command to remove the match criterion.
The match criterion is not configured by default.
Examples
# Configure node 10 of route policy policy1 to permit routing information whose next hop address
matches IPv6 prefix list p1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match ipv6 next-hop prefix-list p1
ip ipv6-prefix
Syntax
ip ipv6-prefix ipv6-prefix-name [ index index-number ] { deny | permit } ipv6-address prefix-length
[ greater-equal min-prefix-length ] [ less-equal max-prefix-length ]
greater-equal, the lower prefix length
less-equal, the upper prefix length
1-29
Description