Igmp-Snooping Static-Group - 3Com S7906E Command Reference Manual

Description
Use the igmp-snooping special-query source-ip command to configure the source IP address of
IGMP group-specific queries.
Use the undo igmp-snooping special-query source-ip command to restore the default configuration.
By default, the source IP address of IGMP group-specific queries is 0.0.0.0.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: igmp-snooping enable.
Examples
# In VLAN 2, enable IGMP Snooping and specify 10.1.1.1 as the source IP address of IGMP
group-specific queries.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] qui
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping special-query source-ip 10.1.1.1

igmp-snooping static-group

Syntax
igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id
undo igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id
View
Ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
group-address: Address of the multicast group to be statically joined, in the range of 224.0.0.0 to
239.255.255.255.
source-address: Address of the multicast source to be statically joined. The value of this argument
should be a valid unicast address or 0.0.0.0. If the value is 0.0.0.0, this means no multicast source is
specified.
vlan vlan-id: Specifies the VLAN that comprises the port(s), where vlan-id is in the range of 1 to 4094.
Description
Use the igmp-snooping static-group command to configure the static (*, G) or (S, G) joining function,
namely to configure the current port or port group as static multicast group or source-group member(s).
Use the undo igmp-snooping static-group command to restore the system default.
By default, no ports are static member ports.
Note that:
1-21