If-Match Route-Type - 3Com S7906E Command Reference Manual

Parameters
None
Description
Use the if-match mpls-label command to specify the MPLS label match criterion.
Use the undo if-match mpls-label command to remove the match criterion.
The match criterion is not configured by default.
Examples
# Configure node 10 in permit mode of route policy policy1 to match the MPLS labels of routing
updates.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match mpls-label

if-match route-type

Syntax
if-match route-type { internal | external-type1 | external-type2 | external-type1or2 | is-is-level-1 |
is-is-level-2 | nssa-external-type1 | nssa-external-type2 | nssa-external-type1or2 } *
undo if-match route-type [ internal | external-type1 | external-type2 | external-type1or2 |
is-is-level-1 | is-is-level-2 | nssa-external-type1 | nssa-external-type2 | nssa-external-type1or2 ] *
View
Route policy view
Default Level
2: System level
Parameters
internal: Internal routes (OSPF intra-area and inter-area routes).
external-type1: OSPF Type 1 external routes.
external-type2: OSPF Type 2 external routes.
external-type1or2: OSPF Type 1 or 2 external routes.
is-is-level-1: IS-IS Level-1 routes.
is-is-level-2: IS-IS Level-2 routes.
nssa-external-type1: OSPF NSSA Type 1 external routes.
nssa-external-type2: OSPF NSSA Type 2 external routes.
nssa-external-type1or2: OSPF NSSA Type 1 or 2 external routes.
Description
Use the if-match route-type command to configure a route type match criterion.
Use the undo if-match route-type command to remove the match criterion.
The match criterion is not configured by default.
1-17