Ospf Timer Hello - 3Com 5500G-EI Command Reference Manual

Parameter
seconds
65535.
Description
Using the
time allowed to OSPF neighbors, in seconds.
Using the
By default, the dead time allowed to OSPF neighbors is 40 seconds.
If no Hello message is received from a neighbor in the specified time, the neighbor
is considered unresponsive or down. The
four times that of the
the same network segment must be identical.
Related commands:
Example
To set the dead time to 80 seconds on interface Vlan-interface 1, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Vlan-interface 1
[SW5500-Vlan-interface1]ospf timer dead 80

ospf timer hello

Syntax
ospf timer hello
undo ospf timer hello
View
VLAN Interface View
Parameter
seconds
Description
Using the
allowed for an interface.
Using the
default value. By default, the amount of time allowed is 10 seconds for an
interface of
p2mp
Related command:
Example
To set a time interval of 20 seconds for transmitting Hello messages on the
interface Vlan-interface 1, enter the following:
Enter the amount of dead time allowed, in seconds, in the range 1 to
ospf timer dead
undo ospf timer dead
timer
ospf timer hello
seconds
Enter the Hello interval time allowed, in seconds, in the range 1 to 255.
ospf timer hello
undo ospf timer hello
or
p2p broadcast
type.
ospf timer dead
OSPF Configuration Commands
command, you can configure the amount of dead
command, you can restore the default value.
timer
dead
value. The
timer
hello
.
command, you can configure the Hello interval time
command, you can restore the interval to the
type, and 30 seconds for an interface of
.
211
value should be at least
value for routers on
dead
nbma
or