3Com S7906E Command Reference Manual page 810

Priority
Retransmit Timer Value
Retransmit-Throttle Timer
BFD
Tunnel L1 State
Tunnel L2 State
Tunnel Type
Tunnel Metric
Destination Router ID
Table 1-3 display isis interface command output description
Field
Interface
Id
IPV4.State
IPV6.State
MTU
Type
DIS
SNPA Address
IP Address
Secondary IP Address(es)
IPV6 Link Local Address
IPV6 Global Address(es)
Csnp Timer Value
Hello Timer Value
Hello Multiplier Value
Lsp Timer Value
Cost
Priority
Retransmit Timer Value
BFD
MPLS TE Status
INTF L1 TE Status
INTF L2 TE Status
TE Cost
TE Admin Group
TE Max Bandwidth
TE Max Res Bandwidth
Tunnel L1 State
: L1 64 L2 64
: L12 5
: L12 33
: Disabled
: OFF
: ON
: AA
: 0
: 5.5.5.5
Interface type and number
Circuit ID
IPv4 state
IPv6 state
Interface MTU
Interface link adjacency type
Whether the interface is elected as the DIS or not
Subnet access point address
Primary IP address
Secondary IP addresses
IPv6 link local address
IPv6 global address
Interval for sending CSNP packets
Interval for sending Hello packets
Number of invalid Hello packets
Minimum interval for sending LSP packets
Cost of the interface
DIS priority
LSP retransmission interval over the point-to-point link
Whether BFD is enabled on the interface
Whether MPLS TE is enabled on the interface
Whether level-1 MPLS TE is enabled on the interface
Whether level-2 MPLS TE is enabled on the interface
MPLS TE cost configured on the interface
TE link administration group
TE link maximum bandwidth
TE link maximum reserved bandwidth
IS-IS TE tunnel level-1 state
1-11
Description