Sflow Interval - 3Com S7906E Command Reference Manual

Parameters
inbound: Samples inbound packets.
outbound: Samples outbound packets.
Description
Use the sflow enable command to enable sFlow in the inbound or outbound direction on the port.
Use the undo sflow enable command to disable sFlow in the inbound or outbound direction on the
port.
sFlow is disabled by default.
If you want to enable sFlow on an aggregation group, you need to enable sFlow on each member port.
Examples
# Enable sFlow in the outbound direction on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] sflow enable outbound

sflow interval

Syntax
sflow interval interval-time
undo sflow interval
View
System view
Default Level
2: System level
Parameters
interval-time: Counter sampling interval in seconds, in the range 2 to 200.
Description
Use the sflow interval command to configure the counter sampling interval.
Use the undo sflow interval command to restore the default interval.
By default, the sampling interval is 20 seconds.
Examples
# Configure the counter sampling interval as 50 seconds.
<Sysname> system-view
[Sysname] sflow interval 50
1-4