mld-snooping host-aging-time
Syntax
mld-snooping host-aging-time interval
undo mld-snooping host-aging-time
View
VLAN view
Default Level
2: System level
Parameters
interval: Dynamic member port aging time, in seconds. The effective range is 200 to 1,000.
Description
Use the mld-snooping host-aging-time command to configure the aging time of dynamic member
ports in the current VLAN.
Use the undo mld-snooping host-aging-time command to restore the system default.
By default, the dynamic member port aging time is 260 seconds.
This command takes effect only if MLD Snooping is enabled in the VLAN.
Related commands: host-aging-time.
Examples
# Set the aging time of dynamic member ports to 300 seconds in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping host-aging-time 300
mld-snooping host-join
Syntax
mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
undo mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
View
Ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
ipv6-group-address: Address of IPv6 multicast group which the simulated host is to join. The effective
range is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y represent any
hexadecimal number between 0 and F, inclusive.
1-14
Need help?
Do you have a question about the S7906E and is the answer not in the manual?