Display Mpls Statistics Interface - 3Com S7906E Command Reference Manual

Out-Interface
NextHop
Static-Lsp Type: IPTN
Lsp Status
Table 1-11 display mpls static-lsp verbose command output description
Field
LSR-Type
Static-Lsp Type

display mpls statistics interface

Syntax
display mpls statistics interface { interface-type interface-number | all }
View
Any view
Default Level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
all: Specifies all interfaces.
Description
Use the display mpls statistics interface command to display MPLS statistics for one or all interfaces.
Note that:
To display statistics on a device, set the statistics interval first. By default, the interval is 0 and the
system does not collect MPLS statistics. In this case, the value of every statistic is 0.
Related commands: statistics interval, mpls statistics enable.
Examples
# Display MPLS statistics for all interfaces.
<Sysname> display mpls statistics interface all
Statistics for Interface IN :
Incoming Interface Vlan-interface1
Octets
Packets
Errors
Disables
Failed Label Lookup
Start Time
End Time
Statistics for Interface OUT :
: Vlan-interface1
: 30.1.1.2
: Up
Role of the LSR for the LSP, which can be ingress, egress, or transit
Type of the static LSP
: 0
: 0
: 0
: 0
: 0
: 2008/04/28
: 2008/04/28
Description
10:23:55
10:23:55
1-20