Mpls Lsr-Id - 3Com S7906E Command Reference Manual

Parameters
ip-address: IP address for LDP to use as the TCP transport address.
interface: Specifies that LDP use the IP address of the current interface as the TCP transport address.
This keyword is available only in interface view.
Description
Use the mpls ldp transport-address command to configure an LDP transport address.
Use the undo mpls ldp transport-address command to restore the default.
By default, a transport address takes the value of the MPLS LSR ID.
In interface view, you configure the link Hello transport address; in MPLS LDP remote peer view, you
configure the targeted Hello transport address.
Examples
# On interface VLAN-interface 1, configure the link Hello transport address as the IP address of the
current interface.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] mpls
[Sysname-Vlan-interface1] mpls ldp
[Sysname-Vlan-interface1] mpls ldp transport-address interface
# Configure the targeted Hello transport address to be 10.1.1.1.
<Sysname> system-view
[Sysname] mpls ldp remote-peer BJI
[Sysname-mpls-ldp-remote-bji] remote-ip 3.3.3.3
[Sysname-mpls-ldp-remote-bji] mpls ldp transport-address 10.1.1.1

mpls lsr-id

Syntax
mpls lsr-id lsr-id
undo mpls lsr-id
View
System view
Default Level
2: System level
Parameters
lsr-id: ID for identifying the LSR, in dotted decimal notation.
Description
Use the mpls lsr-id command to configure the ID of an LSR.
Use the undo mpls lsr-id command to remove the ID of an LSR.
By default, no LSR ID is configured.
1-40