Display Mpls Ldp Isp - 3Com S7906E Command Reference Manual

display mpls ldp Isp

Syntax
display mpls ldp lsp [ all | [ vpn-instance vpn-instance-name ] [ destination-address mask-length ] ] [ |
{ begin | exclude | include } regular-expression ]
View
Any view
Default Level
1: Monitor level
Parameters
all: Specifies all LSPs established by LDP.
vpn-instance-name: Name of the VPN instance, a case-sensitive string of 1 to 31 characters.
dest-addr: Destination address of the LSP.
mask-length: Length of the mask for the destination address, in the range 0 to 32.
|: Uses a regular expression to filter the output information. For details about regular expression, refer to
Basic System Configuration in the System Volume.
begin: Displays all lines starting with the line that matches the regular expression.
exclude: Displays all lines other than those matching the regular expression..
include: Displays all lines matching the regular expression.
regular-expression: Regular expression, a case-sensitive string of 1 to 80 characters.
Description
Use the display mpls ldp lsp command to display information about LSPs established by LDP.
Related commands: display mpls ldp.
Examples
# Display information about all LSPs established by LDP.
<Sysname> display mpls ldp lsp
--------------------------------------------------------------------------
SN DestAddress/Mask
-------------------------------------------------------------------------
1 1.1.1.1/32
2 10.1.1.0/24
*3 100.1.1.1/32
-------------------------------------------------------------------------- A '*' before an
LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale
LDP LSP Information
In/OutLabel Next-Hop
3/NULL 127.0.0.1
3/NULL 10.1.1.1
Liberal(1025)
1-7
In/Out-Interface
-------/InL0
-------/Eth1/1