3Com S7906E Command Reference Manual page 1547

Description
Use the display mpls lsp command to display information about LSPs.
With no parameters specified, the command displays information about all LSPs.
Related commands: display mpls lsp, display mpls statistics lsp, display mpls static-lsp.
This command supports only VLAN interface.
Examples
# Display information about all LSPs.
<Sysname> display mpls lsp
-----------------------------------------------------------------------
-----------------------------------------------------------------------
FEC
100.1.1.1/32
-----------------------------------------------------------------------
-----------------------------------------------------------------------
FEC
100.10.1.0/24
100.10.1.0/24
168.1.0.0/16
172.17.0.0/16
Table 1-6 display mpls lsp command output description
Field
FEC
# Display detailed information about all LSPs.
<Sysname> display mpls lsp verbose
-------------------------------------------------------------
-------------------------------------------------------------
No.
VrfIndex
Fec
Nexthop
In-Label
LSP Information: L3VPN LSP
In/Out Label In/Out IF Route-Distinguisher
1025/1024 -/-
LSP Information: LDP LSP
In/Out Label In/Out IF
3/NULL -/-
3/NULL -/-
3/NULL -/-
3/NULL -/-
Forwarding equivalence class, in either of the following two forms:
IP address/mask: Assigning labels based on destination addresses.
IP address: Assigning labels based on the addresses of the next hops.
LSP Information: LDP LSP
: 1
:
: 1.1.1.9/32
: 127.0.0.1
: 3
100:1
Description
1-15
Vrf Name
ASBRLSP
Vrf Name