Reset Mpls Ldp - 3Com S7906E Command Reference Manual

Reply from 100.2.3.1: bytes=100 Sequence=3 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=4 time = 62 ms
--- FEC: LDP IPV4 PREFIX 3.3.3.9/32 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 31/55/62 ms
remote-ip
Syntax
remote-ip ip-address
undo remote-ip
View
MPLS LDP remote peer view
Default Level
1: Monitor level
Parameters
ip-address: Remote peer IP address.
Description
Use the remote-ip command to configure the remote peer IP address.
Use the undo remote-ip command to remove the configuration.
Note that the remote peer IP address must be the MPLS LSR ID of the remote peer. Two peers use their
MPLS LSR IDs as the transport addresses to establish the TCP connection.
Related commands: mpls ldp remote-peer.
Examples
# Configure the remote peer IP address.
<Sysname> system-view
[Sysname] mpls ldp remote-peer BJI
[Sysname-mpls-ldp-remote-bji] remote-ip 3.3.3.3

reset mpls ldp

Syntax
reset mpls ldp [ all | [ vpn-instance vpn-instance-name ] [ fec mask | peer peer-id ] ]
View
User view
1-43