3Com S7906E Command Reference Manual page 1595

Parameters
interface interface-type interface-number: Specifies the interface connecting the CE by its type and
number.
remote-info: Specifies Martini VCs from the remote peer.
Description
Use the display mpls l2vc command to display information about Martini VCs configured on the router.
If you specify an interface, the command displays information about Martini VCs configured on the CE
interface.
Examples
# Display information about all Martini VCs configured on the router.
<Sysname> display mpls l2vc
total ldp vc : 3
Transport Client
VC ID Intf
5 Vlan2
6 Vlan3
7 Vlan4
Table 1-9 display mpls l2vc command output description
total ldp vc
Transport VC ID
Client Intf
VC State
Remote VC Label
Tunnel Policy
# Display information about Martini VCs received from the remote peer.
<Sysname> display mpls l2vc remote-info
total remote ldp vc : 1
Transport Group
VC ID ID
100 0
Table 1-10 display mpls l2vc remote-info command output description
Field
total remote ldp vc
Transport VC ID
Group ID
Peer Addr
0 up 3 down
VC Local
State VC Label
down 0
down 0
down 0
Field
Peer Remote
Addr Encap
3.3.3.9 ethernet
Total number of remote LDP VCs
Remote VC ID
Remote VC group ID, used for the L2VPN VC FEC TLV field of
LDP messages
IP address of the peer
1-12
Remote Tunnel
VC Label Policy
0 lsp3
0 lsp2
0 plcy3
Description
Total number of Martini VCs
Remote VC ID
Interface connected with the CE
Status of the VC
Remote VC label
Tunnel policy configured
Remote C
VC Label Bit
1025 0
Description
Remote
MTU
1500