Static-Lsp Ingress - 3Com S7906E Command Reference Manual

in-label: Incoming label value, in the range 16 to 1023.
Description
Use the static-lsp egress command to configure a static LSP taking the current LSR as the egress.
Use the undo static-lsp egress command to remove a static LSP taking the current LSR as the
egress.
Related commands: static-lsp ingress, static-lsp transit, display mpls static-lsp.
Examples
# Configure a static LSP named bj-sh, taking the current LSR as the egress.
<Sysname> system-view
[Sysname] static-lsp egress bj-sh incoming-interface vlan-interface 2 in-label 233

static-lsp ingress

Syntax
static-lsp ingress lsp-name destination dest-addr { mask | mask-length } nexthop next-hop-addr
out-label out-label
undo static-lsp ingress lsp-name
View
System view
Default Level
2: System level
Parameters
lsp-name: Name for the LSP, a string of 1 to 15 characters.
dest-addr: Destination IP address of the LSP.
mask: Mask of the destination IP address.
mask-length: Length of the mask for the destination address, in the range 0 to 32.
next-hop-addr: Address of the next hop.
out-label: Outgoing label, in the range 16 to 1023.
Description
Use the static-lsp ingress command to configure a static LSP taking the current LSR as the ingress.
Use the undo static-lsp ingress command to remove a static LSP taking the current LSR as the
ingress.
Note that:
If you specify the next hop when configuring a static LSP, and the address of the next hop is
present in the routing table, you also need to specify the next hop when configuring the static IP
route.
If you specify the outgoing interface when configuring a static LSP, you also need to specify the
outgoing interface when configuring the static IP route.
The address of the next hop cannot be any local public network IP address.
1-46