Set Synchronization - Avaya S8700 Maintenance Manual

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

set synchronization

This command sets a specific DS1 trunk, Tone-Clock circuit, or ATM switch as the

reference source for system synchronization signals. It is permitted only after

synchronization has been disabled with disable synch . Any administered DS1

trunk or active Tone-Clock may be entered with the set command. The DS1 or

Tone-Clock will remain the synchronization reference until either the set command

specifies another circuit pack, or enable synchronization is entered.

After an enable synchronization , the administered primary or secondary

synchronization source will become the synchronization reference. If no primary

or secondary source is administered, the active Tone-Clock is used as the

synchronization reference.

This command is not supported when ATM-PNC is enabled.

Table 7-44. set synchronization command parameters

Action/ Object

set synchronization

set synchronization 8a01

Command successfully completed

Qualifier Description

Issue 1 May 2002

Interactions