Avaya S8700 Maintenance Manual page 557

status bri-port
Table 7-45. Interpreting BRI-Port Status Reports — Continued
Error Aux
Type Data Associated Test
ASAI 0-126 Hyperactive
BRI
ASAI 0-126 L3-Restarting
ASAI 0-126 L3-Restarted
ASAI 0-126 L3-Established
555-233-143
Alarm On/Off
Level Board Test to Clear Value
ignore ignore Link has sent too many messages
per unit time. Signaling has been
suspended. After 60 seconds, the
system attempts to put the link into
service. If a link remains in this state
while there is no activity at the BRI
endpoint, take the following steps:
1. Make sure SPID administration
2. Try replacing the endpoint.
ext# The switch has sent a Restart
message to the adjunct but has not
yet received a Restart
Acknowledgment message from the
adjunct.
ext# After receiving a Restart
Acknowledgment message, the
switch has sent a Heartbeat
message to the adjunct and is
waiting for a response.
ext# This is the normal state for ASAI
adjunct.
on the switch and endpoints are
consistent. Repeat status
bri-port to determine whether
the Layer 2 state of the
signaling link is
L3-Established . If it is
not, go to Step 2.
Repeat status bri-port to
determine whether the Layer 2
state of the signaling link is
L3-Established . If it is
not, follow normal escalation
procedures.
Continued on next page
Issue 1 May 2002 7-301