Avaya S8700 Maintenance Manual page 575

status conference
Drop Reason
(cont'd)
Administered Connection Number - from 1 to 128. AC number can be used to
AC Num
further diagnose a problem by combining status conference information with the
status administered connection command and data stored in the error and
alarm logs.
The data endpoint that the channel is using.
Ports Trunk
The MMI port for the channel.
Ports Video
If the endpoint type is not "UCC," the VC audio encoder port (which is always
Ports Aud
paired to a decoder port) for the channel (only the first channel). Because only
one audio encoder port is allocated per endpoint, it appears together with the
ESM data port in the endpoint's channel 1 port slot position of the Port
Aud/ESM column. For "UCC" endpoint type, the channel 1 port slot position
displays the allocated Call Classifier resource.
The Expansion Service Module MMI data port. This field is always blank.
Ports ESM
Endpoint's assigned summer group number. The summer group port
Sum Grp
assignments are on screen 1.
For Avaya use only.
software
Output (status conference endpoint)
status conference x endpoint y
The first screen appears when status conference x endpoint y is entered and
the specified conference is found. Data relevant for each endpoint displays in 6
pages. If the endpoint-ID of all is used, every possible endpoint associated with
the specified conference displays.
555-233-143
Resource MCU could not provide resources (VC or MMI) when the call
arrived or lost the resources during the call. This could be due to them
being Out of Service, busied out by craft, or being used by system
maintenance. This drop reason could also occur if the DS1/MMI cable is
disconnected. If there was a resource problem when the call arrived, it
would get reorder (fast busy) and not get disconnected by the MCU.
Password Either the user entered the wrong password or the audio
add-on user did not enter it within the specified time period. Note that the
audio add-on user gets one attempt to enter a correct password and
inter-digit timing for each digit (that is, about 10 seconds between digits).
System An MCU restart (level 2) disconnected every call.
The user entered an invalid User Identification Number.
UIN-Inv
Unknown The system could not determine the cause of the disconnect.
This dial-out drop reason occurs when the MCU detects the
Wrong-num
wrong destination number was dialed. This drop reason is detected by
MCU CPTR resources SDN cause value. See "Dial-out" for details.
controller intentionally disconnected the endpoint.
UCC
Issue 1 May 2002 7-319