Avaya S8700 Maintenance Manual page 554

Maintenance Commands
Table 7-45. Interpreting BRI-Port Status Reports — Continued
Error Aux
Type Data Associated Test
BRI, 64-126 L3-Established
ASAI
BRI 64-126 L3-Established
BRI 0-126 L3-Established
7-298 Issue 1 May 2002
Alarm On/Off
Level Board Test to Clear Value
blank yes A demand SPID Facility test is in
progress on the port, and the link is
not currently associated with a BRI
endpoint. See SPID Facility test's
procedures described in the
BRI-SET section of
''Maintenance-Object Repair
Procedures''.
ext# yes A demand SPID Facility test is in
progress on the port, and the link is
associated with an endpoint on the
port. See SPID Facility test's
procedures described in the
BRI-SET section of
''Maintenance-Object Repair
Procedures''.
blank blank An invalid SPID is assigned to link.
1. Change the SPID value in the
Chapter 8,
Chapter 8,
BRI endpoint to match the SPID
administered to the BRI
endpoint on the port. Repeat
status bri-port to determine
whether the Layer 2 state of the
signaling link is
L3-Established . If it is
not, follow normal escalation
procedures.
Continued on next page
555-233-143