Execution Errors - Agilent Technologies 35670A Manual

Execution Errors

Amplitude selections are meaningless for the current combination of Meas Data and Trace Coord selections.
Blank lines or Laurent terms cannot be changed, deleted or undeleted.
Bode diagram available in 2 or 4 channel FFT ANALYSIS, SWEPT SINE, or ORDER ANALYSIS with
TRACK ON.
CAPTURE ABORTED !!
A measurement parameter was changed.
Pressed [ ABORT CAPTURE ] softkey.
Specified maximum RPM for tachometer < actual RPM; maximum RPM is too small.
Can't move the marker reference to the power band.
Cannot continue capture playback.
Cannot continue measurement Measurement state has changed or Calibration has run Press START to take
new data (existing data will be lost).
Cannot edit an empty data register.
Capture cannot be used with Inst Mode SWEPT SINE.
Channel 1 input cannot be disabled.
Channel 2 trigger only available with two or more active channels (Inst Mode, CHANNELS 2 or CHANNELS
4).
Constant trace. No frequency and damping.
Conversion failure. Double precision overflow.
Curve fit may be poor. Coherence around peaks in weighting function is too low.
Data Tables cannot be turned ON with FRNT/BACK display formats.
Delete program Not Allowed while RECORDING ENABLED.
Does not match marker units.
Double integrations are not allowed on time domain data.
Download program not Allowed while RECORDING ENABLED.
Exponent overflow. E+308 limit exceeded.
Exponent underflow. E-308 limit exceeded.
[Function register] definition is not valid for execution.
[Function register] execution requires recursion.
[Function register] not defined.
FREQUENCY RESPONSE, COHERENCE, and CROSS SPECTRUM data are not valid with
PEAK HOLD average.
Fell out of real time data acquisition. .
File operation aborted, Capture changed.
File operation aborted, Capture in progress.
File operation aborted. Waterfall changed.
File operation aborted. Waterfall register changed.
File operation not completed.
Fit aborted. Curve fit algorithm failed. Must change input to curve fit.
Fit aborted. Trace A data cannot be Octave.
Fit aborted. Trace A data invalid.
Fit aborted. Trace A data must be 32-bit floating point.
Fit aborted. Trace A data must be LINEAR or LOG spaced.
Error Messages
Execution Errors
C-3