Agilent Technologies 35670A Manual page 637

TRIGger[:IMMediate]
Triggers the analyzer if TRIG:SOUR is BUS.
Command Syntax:
Example Statements:
Attribute Summary:
Description:
This command triggers the analyzer if the following two conditions are met:
The GPIB is designated as the trigger source. (Send the TRIG:SOUR:BUS command.)
The analyzer is waiting to trigger. Bit 5 of the Operation Status condition register must be set.
The command is ignored at all other times.
The *TRG command has the same effect as TRIG:IMM. It also has the same effect as the GPIB bus
management command Group Execute Trigger (GET).
For more information about how to use status registers, see "Programming the Status System" in the
GPIB Programmer's Guide .
TRIGger[:IMMediate]
OUTPUT 711;":TRIGGER"
OUTPUT 711;"trig:imm"
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
no
confirmed
TRIGger
command
24-5