TRACe
This command differs from the MMEM:STOR:WAT command. The MMEM:STOR:WAT command
saves a waterfall display to a file. TRAC:WAT:DATA saves a waterfall to one of the waterfall registers.
The query form of this command transfers data from the analyzer over the bus to your controller.
Note
Alias data is included in frequency domain data. Table 23-2 (page 23-4) specifies which
data points are alias-protected and which data points are not protected. The number of
points is determined by the lines of resolution set with the
[SENSe:]FREQuency:RESolution command.
For more information about transferring block data, see Appendix F, "Example Programs," or the GPIB
Programmer's Guide .
23-6