Agilent Technologies 35670A Manual page 624

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

The query form of this command transfers data from the analyzer over the bus to your controller.

Alias data is included in frequency domain data. Table 23-2 specifies which data points

are alias-protected and which data points are not protected. The number of points is

determined by the lines of resolution set with the [SENSe:]FREQUency:RESolution

Sending block data to a data register is valid only if the data register contains data. That is, you can only

replace existing data in the data register. You cannot transfer block data to an empty data register. For

more information about transferring block data, see Appendix F, "Example Programs," or the GPIB

Programmer's Guide .

First point is Point 0.

Lines of Resolution

First point is Point 0.

Not Protected